Summary of Contents for Camp-let tent trailer
- Page 1 t H e H o L i D A Y G L o B e t r o t t e r - a Danish quality product user instructions roYAL...
-
Page 2: Table Of Contents
table of contents: Introduction ............3 Coupling .............. 4 Erecting ............... 5 Kitchen section ..........11 Technical specification ........12 Remember before you go ........13 Remember when you get home ......14 Good advice ............15 Details ..............16 Winter storage ........... -
Page 3: Introduction
These instructions are to be used after you have re- ceived your detailed Camp-let demonstration from your dealer. We have gathered vast experience in the use and erection of Camp-let. By studying these instructions carefully and following... -
Page 4: Coupling
Fog light Blue Earth White Indicator right Green Light right Brown Stop light Light left Black Constant+ Grey *only with 13 pole plug Double check the Camp-let is firmly hitched to your car and check all the lights are working. -
Page 5: Erecting
Lower the front parking leg so the The rear supporting legs has to be screwed down and adjusted, so that trailer is level. the trailer stands horizontal in both directions. The supporting legs must be screwed down so the wheels nearly lets go of the ground. - Page 6 erecting… Before the lid can be lifted, the internal Take off the strap. catch must be released. Lift the lid and slowly lower down. The supporting legs must be adjusted, so that the lid is horizontal. Pivot fitting in transport position. Pivot fitting prior to lifting out the canvas.
- Page 7 Open the zips at the top. Remove and store the protective caps, they have to be put on again, when the tent is being packed away. Pull the canvas free in one of the cor- Mount the middle piece. Pull the canvas ners, so the bar can swing free.
- Page 8 Check again that the pivot fitting is Check that the polework is centrally opened out. Hold the sliding bars on (on all 4 corners) positioned on the both sides and pull the tent up carefully. reinforcements. See the list of poles on page 19. Mount the roof supporting pole, at first in the gable Put the 3 small portal bars in by rolling ...
- Page 9 Push the sliding bars out until the win- Press stud the under bed storage/ dows are horizontal. ground piece into position. Zip the under bed storage/ground piece Mount the wardrobe bar. together with the canvas on both sides. Mount the sofa. The strap from the chair back is passed through the hole in the cloth and fas- tened.
- Page 10 Pegging Note! All zips must be closed. Using the plastic pegs, start the pegging as per dia- gram, then peg in a straight line from corner to corner. Only peg the mud flaps down in poor weather using the steel wire pegs. After pegging mount the supporting poles in each corner.
-
Page 11: Kitchen Section
Kitchen section… Open the kitchen and slowly swing it out Pivot the supporting leg down, and checking that the electrical cable does tighten the wing nuts, so the kitchen is not catch the bolts next to the hinge. horizontal. Gas pressure: 30 mBar. Battery holder takes 2 x 6V batteries to run the water pump. -
Page 12: Technical Specification
Technical specifications 160 cm 160 cm 400 cm Dimension Net weight Load capacity Total... -
Page 13: Remember Before You Go
Before setting off, the Camp-let must be packed with the weight evenly spread. The optimum tow hitch weight is 25-30 kg. The fibre glass trailer body has a 600 ltr. capacity (aprox). There is extra storage space on the luggage rack. It is better to load the Camp-let whilst it is up. -
Page 14: Remember When You Get Home
If you have packed away the Camp-let wet or even slightly damp, you must set up and completely dry it out (within 24 hours). If you have been travelling in wet conditions you must open up the Camp-let (within 24 hours) to check that water has not seeped in. -
Page 15: Good Advice
Good advice… Dismantling is in reverse order, remember to fold down the back rest and lye the cushions in the bottom of the trailer. Remove the centre awning pole and put the protective sleeves on. Take care not to trap the canvas under the lid and around the kitchen area. Front and rear clamps must be closed and the kitchen is locked. -
Page 16: Details
Details Ventilation for the sleeping Kitchen window guyed out for compartments ventilation Curtain clips The under bed storage can be mounted before the lid is lifted over The entire side window can be zipped/ The veranda doors/windows can be rolled up, so the window area is one big totally or partially opened mosquito net... -
Page 17: Winter Storage
The optimum way to store the Camp-let is in the garage or car- port. It is possible to store the Camp-let on its side (in a garage) using Camp-let side storage brackets available from your dealer. -
Page 18: Maintenance
Wheels, axles & hinges: Check the wheel bearings for slackness and abnormal sounds. If your Camp-let is fitted with overrunning brakes, disconnect the brake drum, check the brake linings and remove brake dust. Lubricate the links and cables and adjust the brakes (to be done once a year or for every 3000 km). - Page 19 List of framework for royal: 1: Roof supporting pole 2: Wardrobe bar 3: Supporting poles 4: Veranda bar (side window) 5: Veranda bar (front window) 6: Ventilation poles (kitchen window) 7: Ventilation poles 8: Veranda bars (side window) 9: Portal bars (canopy)
- Page 20 The product program today includes Camp-let trailer tents as well as Euro- trailer and Mustang horse trailer. - a Danish quality product Camp-let A/S · Arnum : DK- 6510 Gram Tel. +45 74 82 61 35 : Fax +45 74 82 65 80 www.camp-let.dk...